Never worked with dimple dies, is there a trick to keeping the plate flat after you have pressed the dimples in, on some I have seen the material warps a little bit from pressing the material.
Never worked with dimple dies, is there a trick to keeping the plate flat after you have pressed the dimples in, on some I have seen the material warps a little bit from pressing the material.
More pressure. Another trick on parts with holes close to the edge is to remove the male side of the die after forming the dimple and then pressing it again with the female side of the die onto a flat surface. Let me know if that does not make sense. I will be working some dimples soon. I can take some pics.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.