Yer basic ole welding table.

Discussion in 'General Fabrication' started by OcalaWill, Oct 29, 2017.

  1. OcalaWill

    OcalaWill Well-Known Member

    Joined:
    Jun 22, 2016
    Messages:
    206
    Likes Received:
    37
    Trophy Points:
    108
    I just finished it. It is 4’x8’, using 2-1/2 x 1/4 angle, 2x3 tubing and 3/8” top. Piece of expanded metal goes on bottom probably but not sure yet.

    I have been working on a 3x4’ table which has gotten too small, so this should be good!

    F8B59DAE-E50B-4BC9-94C5-7C5EB2800B4A.jpeg 2D98123E-7223-4BFA-999C-0AB664E575D7.jpeg
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice