Robert Donahue
New Member
Hello, I am having torch issues that just started. As I run the program my torch will pierce and cut intermittently. Sometimes it will touch back off but not fire. Or it will touch and fire but then go out. Other times it will finish a cut but the torch stays on while moving across to the next pierce point cutting the sheet as it moves.
What I found so far,, in the AVHC a fuse was blown (RED BOX) I replaced it but still have issued.
I replaced consumables, cleaning out the torch body, same issues still
The height control lifter moves freely.
I opened all the control boxes to inspect and clean out, no change still
I have good ground clamp plus grounded the table to the plasma machine frame.
Any suggestions?
What I found so far,, in the AVHC a fuse was blown (RED BOX) I replaced it but still have issued.
I replaced consumables, cleaning out the torch body, same issues still
The height control lifter moves freely.
I opened all the control boxes to inspect and clean out, no change still
I have good ground clamp plus grounded the table to the plasma machine frame.
Any suggestions?