Arkansas Metal Art
Well-Known Member
This guy has a podcast. This was for his studio room. About 38" wide.
Last edited by a moderator:
Internally LED lit sign
- Thread starter Arkansas Metal Art
- Start date
L
LECS-Chad
Guest
That turned out really nice. great layer job on that!
Arkansas Metal Art
Well-Known Member
Bend and weld. 20 gauge. Next time I'll use 22g. The 20g was a little stiff for the tight angles and tolerances.
I should have taken build pics. I cut rings that set about 1/2" inside the outside diameter of the sign and followed the same contour, then bent the 20g around the rings after I welded the rings to the front and back.
I should have taken build pics. I cut rings that set about 1/2" inside the outside diameter of the sign and followed the same contour, then bent the 20g around the rings after I welded the rings to the front and back.
