DanGeorgian
Well-Known Member
Has anyone had a vfc box "go Bad"? what kind of issues does it cause? is it known what causes it?
im having height sensing issues.
i cleaned all my surfaces including the torch tip.
i set all my parameters per material thickness.
its sensing when it touches the material.
its set to auto mode and sample voltage is on.
everything is grounded 6 ways to sunday.
its not height adjusting while cutting.
its not returning the z axis to its original position when it returns to program zero. (it just stays at the "pierce height")
Any ideas?
im having height sensing issues.
i cleaned all my surfaces including the torch tip.
i set all my parameters per material thickness.
its sensing when it touches the material.
its set to auto mode and sample voltage is on.
everything is grounded 6 ways to sunday.
its not height adjusting while cutting.
its not returning the z axis to its original position when it returns to program zero. (it just stays at the "pierce height")
Any ideas?