Small, bench belt grinder build.

Discussion in 'General Fabrication' started by toglhot, Mar 12, 2022.

  1. toglhot

    toglhot Member

    Joined:
    Mar 7, 2022
    Messages:
    13
    Likes Received:
    2
    Trophy Points:
    18
    This is a small belt grinder I made some time ago. Originally it had two belts, but the motor didn't have enough power to turn them, so I converted it to a single belt. I chose this size belt because there is a very wide variety of grits available. The table is adjustable and there is a platen behind the belt. The wheels were turned up from Delrin, the top wheel have bearings either side. Tracking is adjusted via the knurled knob next to the top wheel. Yes, I know the belt is on the wrong way. grind1.jpg grind2.jpg grind3.jpg grind4.jpg
     
  2. LECS Hunter

    LECS Hunter Administrator

    Joined:
    Feb 10, 2021
    Messages:
    53
    Likes Received:
    2
    Trophy Points:
    78
    Rad design!
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice