Shuttle not powering on

[GarageNerd]

Finally allowed to do business again and the pc isnt powering on.

I ran a job, it sat then I went back out and it had disconnected from accumove. Shut it down, no life when I hit the power button.

Edit: the power cord is good, it works on another pc

Any ideas?

 

[G. Lopez]

Same here! Just turned on flexcut, powerd up the Accumove and walked to the export the design when I came back to do my DATUM and insert the USB I noticed the screen was still off. I checked all my connections and everything looks good. It just seems like the PC is not booting up!

Did you contact Lincoln (Torchmate)? Any troubleshooting steps?