TheGarageBay
Active Member

Pictured above is 1/4 plate 3x4 roughly . Line speed at about 50ipm
air pressure at 85psi
pierce height at .16
cut height at .08
arc voltage at 136
flexcut 80 running at 60 amps
New issue sprung this evening ... machine now cuts as if a 5 year old was holding the torch lead as i datum the machine I get a horrible noise from the motor and it does not want to get into position ... any ideas? I haven’t had time to tweak the machine with the holidays and all , need a job done for tomorrow night and now I’m stuck in the water
Video