1-AMP 250-Volt Fuse keeps blowing up on my Hypertherm

MDZ

New Member
Good afternoon,

Anyone have or had the same issue?
 

Attachments

  • 370DFCA4-1F9E-4B55-8218-D36671574FD9.jpeg
    370DFCA4-1F9E-4B55-8218-D36671574FD9.jpeg
    1.5 MB · Views: 8
So as to not play 20 questions this looks like the fuse on a red screen height control box, what plasma cutter are you using. If it is a Cutmaster series make sure you are not using the spade connectors inside those units for raw arc voltage. You should be using Work + (plasma ground cable) and Torch - studs on the circuit board.
 

Attachments

  • CM81, 101, 151 Voltage conections with alternate connections.jpg
    CM81, 101, 151 Voltage conections with alternate connections.jpg
    212.2 KB · Views: 6
I have a hypertherm. C1F38704-46F2-410E-8481-7F1B05BCDAF9.jpeg
 

Attachments

  • A64817EB-D7A3-4714-B9EF-5F259A801F78.jpeg
    A64817EB-D7A3-4714-B9EF-5F259A801F78.jpeg
    1.4 MB · Views: 7
Back
Top