Hey guys, I've been talking to Hypertherm support about my 0-21 error on my Powermax 65, but I was wondering if you guys had any ideas.
I've had my TM 4x4 Growth Series for over a year now and I've cut with 45A Fine Cut no problems! But starting a few weeks ago, I get the 0-21 error, the torch will rise and continue the toolpath but doesn't cut. I read a few forums with Jim Colt saying it has to do with air flow. Pressure gauge reads 130psi to the plasma. I did try a cut with 45A regular consumables, which it cut successfully, but it doesn't look as good as Fine Cut. When I tried the same cut with 45A Fine Cut right after using 45A consumables, it popped the 0-21 code.
So far I've replaced the ground, replaced consumables + swirl ring, checked air pressure while cutting(which doesn't drop below 100psi).
Any ideas?
Thank you.
I've had my TM 4x4 Growth Series for over a year now and I've cut with 45A Fine Cut no problems! But starting a few weeks ago, I get the 0-21 error, the torch will rise and continue the toolpath but doesn't cut. I read a few forums with Jim Colt saying it has to do with air flow. Pressure gauge reads 130psi to the plasma. I did try a cut with 45A regular consumables, which it cut successfully, but it doesn't look as good as Fine Cut. When I tried the same cut with 45A Fine Cut right after using 45A consumables, it popped the 0-21 code.
So far I've replaced the ground, replaced consumables + swirl ring, checked air pressure while cutting(which doesn't drop below 100psi).
Any ideas?
Thank you.