Recent content by Rcktscientist

So today my 4X4 GS / Accumotive 2 crashed, dislodging the torch and it DIDN'T shut down and kept firing dragging along the metal while completely dislodged. Spoke to Alex and he had never seen that before. I videoed it and got it all. I was hoping I could upload the video here but do not see...

4X4 Growth Series with Accumotive 2 controller, Bobcam 30 program. Haven't used system for about a year. Loaded a program and the torch ran the program but didn't move to plate or fire. Been troubleshooting for days. Torch fires when pins jumpered. Thought it was a post issue as instead of M64...

I reset the Hypertherm and that fixed issue. Still crashed on last hole and I needed to run 3 times to get the part complete.

So I was having intermittent issues I posted yesterday. I decided to try some new consumables and adjust some parameters and try again this morning. Ran program in dry mode, looked good. Started program in dry mode, switched to active where it stopped, torch touched, got Ohmic sensor light...

Still sorting out my 4X4 GS. Sometimes works fine but often have Height Control/Ohmic issues. Cutting 1/2 inch mild steel with Hypertherm 65. Cut 3/4 of the 18 holes OK then the torch stopped 2 inches above the plate and torch started, shows Ohmic Sensor detected, did it for 2 holes then cut 1...

And I've got to say, I'm very underwhelmed. Instruction manual and videos are very incomplete. I may try to make the class in Reno. Some issues: Nesting-no success yet How to adjust start point. It's random, runs inches in X & Y from program home to cut. How to cut 2 simple rectangles with a...