RelianceWeldservices
New Member
I have an Older torchmate with the blue screen and had a No motor detected fault and cant get jog slide to work no. I had a x axis crash due to someone leaving peice of scrap on the x axis but for some reason it stopped z axis from working.
The torch motor has a red steady light on but every once and awhile it will go green and when i reset the controller it goes back to red. (PWR/servo light) the trajectory light flickers green
I ohm tested the wires via layout from torchmate and everything is good.
also the z axis motor spins freely up and down no binding at all.
I tested the A1 and A2 and im getting 36.64 dc volts
Is there something i can do to test motor before i buy a new motor.
Torchmate is saying buy new motor before i spend the 2500+ just asking if theres anything i can do?
Thanks for your time
The torch motor has a red steady light on but every once and awhile it will go green and when i reset the controller it goes back to red. (PWR/servo light) the trajectory light flickers green
I ohm tested the wires via layout from torchmate and everything is good.
also the z axis motor spins freely up and down no binding at all.
I tested the A1 and A2 and im getting 36.64 dc volts
Is there something i can do to test motor before i buy a new motor.
Torchmate is saying buy new motor before i spend the 2500+ just asking if theres anything i can do?
Thanks for your time