Platemarker

Discussion in 'General Fabrication' started by Jdavin, Feb 13, 2023.

  1. Jdavin

    Jdavin New Member

    Joined:
    Sep 27, 2022
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    16
    I recently installed a platemarker on my 4800 table. Everything works, but when I run a program for the marker it moves the metal every time. I have tried different feed rates and currently, I tried it on 3/16 metal and it was a 4x4 sheet.
    Any advise to what I am doing wrong?
     
  2. LECS Hunter

    LECS Hunter Administrator

    Joined:
    Feb 10, 2021
    Messages:
    53
    Likes Received:
    2
    Trophy Points:
    78
    This is a common setting mishap. Our tech guys will get it working perfectly.
    Give us a call at 775-673-2200 or submit a ticket here: https://torchmate.com/technical-support or email support@torchmate.com
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice