Not Sure What To Do Now?

gearheadmike

New Member
Little back story i'm working on a project car a 1950 Crosley it's a small car but did a larger 4 cyl engine swap and now building a disk brake set up. Brakes are from a 81 civic so not a large set up. I got some 4130 normalized chromoly 1/4" plate for the caliper backing plate. I got my template made and transferred over to the steel. But not sure how it should be cut and how the 2 large holes made?

Thoughts on some stuff is will a abrasive cut off wheel gen to much heat and cause the cut edges to be annealed?

What to use to cut the 2 large holes? Hole saw/drill bit/bridgeport?
 

Attachments

  • 136097320_235612578099374_8194731457845579016_n.jpg
    136097320_235612578099374_8194731457845579016_n.jpg
    480.4 KB · Views: 17
  • 136038463_1058024934609822_2656453950552220117_n.jpg
    136038463_1058024934609822_2656453950552220117_n.jpg
    531.1 KB · Views: 16
Back
Top