I don't think that is the correct solution. It's too unpredictable. Why would the machine not be receiving the ok to move, or more so - what...
A few months back I started having problems with the Ok to Move function of our machine. For example: If the pierce delay is set to 2 seconds,...
We ran water in ours for a few years without incident. Always cycled the water up and down from the chamber a few times after each run of...
It was about a $28 - $30k accident. Luckily nobody got hurt, aside from the water table anyway
Because this can happen.. our TMx exploded from hydrogen build up early this spring. Not fun. [ATTACH]
When I try to group a multi tool pathed part and try machine out put it says there is nothing to cut? It's like grouping messes with the tool...
Got it, seems to be working well. Except I sequenced the cut order on the first part, then I did an array of parts to fill the sheet and it cut...
Understood. Thank you. I've never done a multi tool tool path before, is there anything special I need to setup in CAD beings its all plasma...
Ah! I forgot about the sampling feature. So that will correct the cut height/ voltage difference no matter what the feed rate is? So, it will...
Since there is no sensing delay timer in accumove. If I want to cut 3/8" base plates (4 holes) and program a multi tool cut path, with slower...
Running a gator clamp from the star ground to the material got it working again, thanks for the help! Ive also noticed that periodically the...
So I've ran a jumper from the star ground to the material, touched the plate with the torch, no ohmic. The only time I can get an indication of...
The relay off/on makes the relay click, then I tied the two wires together, lowered torch and the indicator light does not illuminate when I...
Okay, it does click when I hit the relay off/on
Table has been running great thanks to the support from torchmate. Suddenly however, my ohmic sensing has stopped working. No click of the...
The magnetic breakaway wires got caught and pulled out of the actual torch mount. There are three wires, red, green and white. Do the green/red...
So, to avoid hitting the theoretical limits, should I measure the overall length of the rails and gantry from stop to stop and use that...
Okay, one last problem to work through.. I nested a project for a 5x10 sheet, got towards the end and i got an overtravel on Y axis detected, and...
[ATTACH] My parts are getting cut off when I output the tool paths on a 5x10 blank now. I can't seem to find a way to adjust that green square...
IS there a way to measure accuracy of that lifter station? With the old TM 4 driver software, you could set your cut height, leave plasma off and...
Separate names with a comma.
