I found the menu, but the torch does not move up or down when doing the cut. I also checked the corner value and did a factory reste on the...
Hi, Thanks for your response. Sorry for the confusion, I meant to say that the height does move manually, but not with the AVHC. You are also...
I did the steps outlined to determine the voltage and imputed the value in the set voltage and then continued the run, but the entire cut the Z...
Yes, I also noticed some of the broken lines, but copied over the sketch in so many ways trying to eliminate that. It functioned normally in other...
Dont know if I am missing something super simple but the height of the torch does not adjust during the cut. The voltage reading does seem to be...
Hi, Thanks for the response. I attached the DXF.
Hi Everyone, Been having a hard time getting torchmate cad to properly generate a cutting profile for this gear I used the connect path and it...
I do set up the partial retract distance and it works fine. It will run the program go up and down as intended, then at the very end the torch...
Ahh I see, I misunderstood the issue here. My tables Z problem is different, the table will run the entire program without issues (for the most...
Hi, Do you know why this might be the case with a Growth Series table? My torch reaches the end of the program then always heads straight down to...
Thanks everyone for all the help, after months of trying to cut something I made my first cut last week. I found the OK to move signal and wired...
I don't see how to disable the "OK to move" from the BASIC tab.
After looking into it, it doesn't look like my Cutmaster 102 has the "OK to Move" output since it doesn't have the CNC interface board. Ill look...
Hi Everyone, I am new to the site and have a few questions. I have been struggling to get my table up and running for actually over a month. Its...
Separate names with a comma.
