Here is my version and script info
Thanks I gave Dennie the gm file though I have this problem across multiple files. Also, FYI I bought this table last year and it came with a...
I will get you the version info tomorrow when I am back at the machine. I just sent Dennie a video of the situation while it is happening. If I...
Chad, I appreciate the difficulties of creating software and accept that I, as the consumer, have to participate in the beta-testing process or...
Jake, I am only successful doing that ~30% of the time, the rest I get the glitch. Either it won't restart or if we do run from here we get an...
I was hoping that I was making the distinction between the techs themselves and the Tech Support decisions of Lincoln. I have almost 20 years of...
This happens every time there is a tip up or splatter on the tip. Shouldn't happen and the software should get fixed Thanks for the reply this is...
Lets say you are cutting 4 inch diameter irregular shape. It is shown at the bottom left point of your cutting area. You mirror it to fit your...
I then move it to the right side of the cut area and the new cut area is to the left of program zero
The update completed, then I reinstalled VMD and still had the error. I thought reinstalling after the update was the fix
I did the reinstall and an hour later the same error occurred so the recommended fix is not really working
I got the deserialzation error , reinstalled the software, worked for a few hours and now have the same error again.
I agree that the change in Tech Support is profound. I have no problem with the technicians once I am connected. I am on my second table and would...
I have been getting a recurring glitch. If I get a breakaway stop or ohmic detection error stop, I will clear the issue, and do a run from here...
that is the challenge, front to back there is very little clearance for your fingers to drop in a piece of plate and the gantry's are in the way...
when your table is at the front left corner are you outside your cutting area. On mine, I have to move 3 inches towards the rear to be able to...
The front cutting edge is tight against the front rail. I have extra room in the room but no clearance in the front. I would be curious to see h0w...
It was easy to lean the steel against the table and slide it onto the surface. I had my cutting surface flush with the front rail. Now there is a...
I was shocked ( I should have said surprised) because I was told to not remove the crossbars because the gantry rails would not stay square. The...
Separate names with a comma.
