Fixed
So if I'm understanding the instructions correctly, the cable from the controller to the plate arker is already on the table, just tucked in to...
I'm moving the marker from a GS series. Will i need different hardware?
Did both, no go.
There' probably a way better answer but I use center line and delete the original path. You could also break path and break node and delete the...
What was your resolution?
Started up the machine this morning and running into datum issues. Hit datum it starts the process and stalls on moving to datum position afyer a...
Anyone have any?
Yep, more than enough. It shuts off in jobs as it pumps more than is used. Also, no low gas warning on plasma.
No errors anywhere. Hit stop and run again it works fine. Has happened a few times. Again, sorry for all the posts, new equipment jitters and...
Sorry to be a forum hog, but machine stopped with this error.
So here' What I'm talking about. Had a torch breakaway so I zoomed in to reverse back to the last spot the torch had cut and 3 min later it...
In either case, jogging or selecting it takes like a minute to search through the Goode. I'm Looking to avoid all of that downtime.
hers a video showing the slowdown and a pic showing the really big kerf. Please help, my entire business is reliant upon fine cuts. [MEDIA]
It says 4.4 on the top banner. There is a lot of options that are in the manual that don't show up on this version, like the version button for...
here is a video of what it looks like to use the run from here feature for me. PLEASE tell me there is an easier/faster way lol. [MEDIA] you can...
The driver software I used with my growth machine.
Yep, but it causes it to search through 30000 lines and that takes forever. And it doesn't show what' been "cut" so it' hard to know if I'm...
Can' seem to get anywhere near the .035 as shown in the manual on 18g cold. Anyone else run into wide kerf issues?
Running a job at the recommended speeds but it slows way down around curves to the point its melting the job and the kerf goes way up. If i lower...
Separate names with a comma.
