I would need to know what model table you have, it sounds like you either have a 4x00, TM Classic or TM X table. In either case you can first try...
The Z is a stepper motor, when it hits a hard stop the motor will slip, this is why we have the Reset Z function to be able to reset its...
Of the 9 little boxes in the upper left corner click on the center box.
The aluminum block that the torch slides down through these are usually held on by a single bolt, pull the breakaway off and check to see how this...
Any plasma cutter same with HT or TD will work best when you stay in the middle of the cutting chart, cutting thick plate there is no reason to...
Try it with 60 amps consumables and see if you get better results, but leave the amperage at lowest setting.
Try dropping the cut speed some, around 15 to 20% reduction.
There is an inherent delay in the AVHC before it starts to sense the material defined by Distance to Corner found under Machine Settings, or if...
Yes you can use that post as a ground terminal. Do the following tests: Test 1 - Dry run with the the switch set to no cut, does the torch stay...
That saved you about $850 for a new machine torch, thanks for updating your post.
Trick would be to keep most of the heat on the railing, so instead of a 45 degree into the root of the joint, run your pass at a steeper angle...
You are leaving out some critical information such as what plasma cutter you have, but my guess would be to contact the manufacture tech support...
The VMD software has the ability to do plate alignment, possibly someone was messing around and did not realize what they were doing. To set your...
Not a problem as long as you have enough clearance, draw a rectangle representing the tube and drop in into the lower left corner. Place the...
It could be the relay, by-pass the relay to test it. Jump across the start input contacts when the gantry moves into position, this will cause...
You would need to call in to Tech Support and request the upgrade.
Isn't that what I just said ;)
Before you create the tool path you could break path and with it all selected it would show you how many parts you have in the upper left of the...
Go to Layout and click Ungroup. Sometimes when you create a tool path on items that are not able to create a lead-in because the object is too...
Keep the material flat, change plasma to expanded cutting and cut in manual mode.
Separate names with a comma.
