The lifter works off of Touch Torque so the Smart Motor is required, it is like a Hybrid between a stepper motor and a servo motor. Technically...
All you would need is the material thickness, cut speeds would be the same as for flat plate.
Your cut height should be .08 per book specs, you don't mention what the percent override is set to, but regardless if you are having difficulties...
to test the function of the Breakaway, you can pull the torch off and looking at the magnet, below is two horizontal plates. touch the two plates...
You tried 1.3.2 on our website, if 32 bit computer you will need to create a folder on the C drive. C:\program files (x86), copy the Lincoln...
When in doubt reload configuration, Login as Admin go to Machine Settings then Load Configuration, choose your config and leave all check boxes...
There ought to be enough room to run a couple straight lines. Doubt you are going to find many people that cut that material, if in doubt run it...
Lots of different uses for the Array feature, sometimes I will use that instead of nesting.
No communication between motor and control box, you will need to try and reprogram motor. Turn box off, hold down Ok and turn back on, then...
Lead-ins/outs can only fit if the object is large enough, if the object is not large enough to fit a lead-in inside then the object will be...
A picture would be nice so we can properly diagnose the issue. You could have duplicate lines or open objects causing the issues, for either...
With a Growth Series, Reset Z at the top of its travel. Under Job Setup, jog the Z down till you have 2" of clearance, change Retract Mode to...
You can drop the pierce delay to 0, if that works great if not then you can Disable Ok to Move and enter a Pierce Delay. Depending on your...
We no longer support that AVHC box, you could open the cover and take a look at the ribbon cable, make sure it is fully seated. Other than that...
That turned out looking good, like the font you used.
Dotted lines are an open object in the TM Cad software. You can select all go to Arrange > Convert to Polyarc then go back to Arrange > Connect...
Not a tool path, not selected, or not inside the material boundary lines. Make sure when you select the tool path that it says so in the upper...
Hitting Reset Z and the torch drops indicates a broken wire in the switch assembly for the Z axis. Look on the right side of the breakaway, where...
It could be that you did not define the proper feedrate, usually set to 100, this is when you create the Tool Path on the Basic Tab you can enter...
If the retract mode is set to partial under Job Setup then the Z will rapid down a defined distance (as set by retract distance) before it slows...
Separate names with a comma.
