If you have the previous generation controls you can find a guide here at below link. If you have the new Accumove controller you can run the...
For plasma settings you will need to contact Burny/Kaliburn. In your Cad settings set Ignore Layer to 1.
Verify you can open the dxf file into another program such as a dxf viewer that the file is not empty. The Burny controller you may need to...
In your Height Control settings turn AVHC to Auto and set Sample Voltage to On. Also ensure that IHS is On also known as Ohmic is On.
It doesnt, you would need to pause the program after it moved into position to begin plasma cutting, switch back to normal cutting and then resume...
It is no different use the online tool path using the plasma torch tool, set your plasma cutter to marking.
We have some very good tutorials on our website torchmate.com/university. You are receiving that message because your Lead-in length is too large...
TM2, 3 and X all use the same linear slide and cassette, there is only a single set screw on the cassette to take out the play, located on either...
In TM Cad go to Arrange and Make Path with your entire part selected, then go to View and Show Fill to ensure that WYSIWYG, then create your Male...
In the VMD software you can use the Run from Here feature, no need to jog the torch. With a touch screen simply touch and hold on the cut line, a...
This sounds familiar and you may have already fixed the issue but for others that may be interested in knowing, under Tool Library in the VMD...
That is not possible. You would import the part then duplicate in TM Cad either using the Array function or pressing Ctrl +D to duplicate.
Pull the torch out of the lifter and do a dry run, doing this so there is no weight on the lifter, see if it works. The vibrating could be that...
Sounds like this is the fuse that supplies power to the drive boards, the fuse next to the two red wires on the power board. When the fuse blows...
Pull all 4 I/O cables from the back of the box, they are the small round connectors, if you have a TMX water table also unscrew the round limit...
If you have Protext you can adjust the font size after you wrap text around your object, press apply to get out of that mode. Then double click...
You would want to check the indicator lights on the front face of plasma cutter, if two bottom lights are lit then this could indicate an open...
You would want to check that you can ping the controller using Windows Command Prompt, the address to ping would be 192.168.1.7. If you cant ping...
Using the 45 amp fine cut consumables, dial your amperage down to 30 on the plasma and give that a try and you may need to drop your speed some to...
No you cant, not with Torchmate. With the lifter station in pristine condition I have seen TT as low as 12, with the inherent resistance in the...
Separate names with a comma.
