That is an indication that you need to uninstall and reinstall the VMD software.
If that is the case then Disable Ok to Move on the AVHC box, as you do not have the Input cable that goes between the AVHC and the Signal...
Yes you are correct on all accounts. You can go to Controller > Input Line Status and jump across the two Pierce wires on back of AVHC box and...
The platemarker is a valid issue, you would have to physically press stop and when you resume the job it would double the offset. The other two...
If you drew two circles over top of each other you wouldn't know you had two circles as you would only see one. By double clicking on the line to...
You are barking up the wrong tree, steel suppliers are not going to have that data. You need to be looking at Engineering standards, search ASTM...
you will need to contact Burny/Kaliburn, there address is www.burny.com
Using both TM3 and TM4 we are looking for Input line 1 to receive the Ok to Move signal from the AVHC which inturn receives a signal from your...
When you do a dry run, does it follow the pattern. If yes then that indicates the signal from the AVHC to signal generator are in good order. Do...
You will need to contact SigmaNest for any software of post processing issues.
Under Configuration > System > Controller turn off Express Mode then you can change the Max Arc Feedrate. Generally using Express Mode allows you...
Check that your interface wires are connected to port 2 on the back of the Accumove controller, the polarity of the wires do matter so try...
You can use TM Cad to create dxf files, if you have Cad 8 or 9 you will not create a tool path the Burney software would create the tool path for...
That really pops against the background of that wall.
Need more information, such as amperage and cut speed and what consumables you are using. It is advisable to drop cut speeds from the cut...
If you have an Inova height control would recommend reading the Inova manual this controls all functions of the z lifter and height control, can...
Until you figure it out in the mean time you can leave the Ok to Move cable disconnected from the Accumove box, and turn off Ok to Move in the VMD...
I would go through it dissassemble and clean everything, clean the lifting block as you would a gun barrel, run pieces of rag down through the...
Noise is either coming from lead screw/bronze nut or the bushings inside the lifting block.
Too much lube is a detriment has diminishing returns, keep it well cleaned and very lightly lubricated a couple drops of 3 in one oil on top of...
Separate names with a comma.
