Your original post you state the height control does not move but then you go onto say it dives or changes cut height, which is it. Also on your...
Cycle off the Accumove for 15 seconds, close the VMD and reopen software, within 30 seconds of turning on Accumove check to see if the VMD will...
There is a Pierce Delay in the AVHC box, this is two fold, one it determines how long the torch stays at Pierce Height before dropping down to Cut...
I am not sure why you would want to close a path when you are going to index a part, if you close the shape it will cut it in half, you dont want...
Shouldn't be an issue using the AVHC, many people don't understand the concept of how voltage affects cut height. It is best to do a sample run...
Be better if you attached the dxf file.
Are you creating a tool path and showing the original as well as the tool path, that would be a double line. The edu version operates the same as...
Yes Edu version of Cad will open both file types, though normal Cad will not.
You will need to determine what Layer is for Plasma, depending on who or what created the dxf file it may have multiple layers on it. On the...
Drop the amperage if you are cutting at 40 try 30. Run a line speed test in the Window range you think you will get the best quality. Meaning if...
All explained in the Setup and Start Guide TM3 version is here:...
Explained in the test cutting router section. Assuming you are using a router setup file as below. [ATTACH] [ATTACH] [ATTACH]
Use the same settings for Aluminum though your cut speed will be lower due to the thermal conductivity.
Yes this works with TM4.5 software.
The serial number is encoded in the motherboard, the info in the software does not match what is written on outside of box then that would...
I would recommend download and installing TM 4.0 driver software. Then go to File > New Setup and opening the TM2 setup file and change the...
Same price as it has always been, around $250, check with parts department for a current quote.
You are looking in the wrong software, Cad software has nothing to do with routing other than tool pathing, The driver software is what you need...
Yes, it is explained how in the Setup and Start Guide.
There is no reason to scrap a part if you can get back to Program Zero even if you lose position. Use the Run from Here feature to position the...
Separate names with a comma.
