I dont have any replacement parts for the AVHC box itself, we always drop shipped those from Onexia.
The Accumove controller and lifter station are by no means affected by this announcement. Torchmate still carries spare parts for our previous...
Looking at that video. It looks like it is dropping down when it is rapid traveling to the beginning of the next cut. With the cut light off, go...
Line speed test should only be done in Manual mode, not Auto. After you pick the correct speed, you can run the voltage test at that speed to...
Move the lifter in the down position with the box turned off, turn the box back on, does the motor retract the lifter station to the top. After...
Any non connect issues can be addressed by opening Command Prompt in Windows (search for cmd) and typing ipconfig to see if it returns an IP...
What is your dongle # and I can send you a new set of license files, number ends with a H.
Go to Help then About Torchmate and it will display the version #.
If your LC105 is currently working then great you can continue to use it until you deplete your consumables, then switch over to the LC100M. The...
Might need to reinstall, you can download from our website, this will install the fonts, clipart and shape library:...
Something is likely slipping, short of the two set screws on the spur gear you also need to check the two set screws inside the gear box, the...
You must of assembled the gantry 180 out from when you took it apart. Short from swapping two of the wires on the motor cable you will need to...
We no longer sell sidemount tube cutter accessory, the only tube cutter we currently have is our standalone MasterPipe Compact Profiler:...
No, it would apply both dwell times. You could use the G04 command and set the M50 Delay to .1 or 0.
The command for dwell is G04 X15 indicating 15 seconds could change it to .1 if you want to dwell for 10th of a second. What version of TM...
You would need to determine if the Accumove is talking to the computer, simplest way is to open Command Prompt (search CMD in windows) and type in...
What version is the software seeing based on the license files, open TM Cad and at the top of the screen it will display the version, whether it...
Yes the tool library setting are stored on the CutTmpl.mdb data base file located in the TM Cad folder on the C drive. You can save and load a...
ABove where it displays your job on the screen, you have a couple tabs up there, one of them will be Height Control. Here you can watch what the...
You would only want to use Nitrogen for cutting Aluminum and or Stainless.
Separate names with a comma.
