Search Results

Search Again
Page 5 of 5
  1. Fastyankee13
    Thread

    Torch diving in to table

    I was just trying to cut a piece of 3/8 thick steel and the torch would start burning for about an inch than dives in to the material. I ended up...
    Thread by: Fastyankee13, Apr 24, 2017, 8 replies, in forum: CNC Cutting
  2. Fastyankee13
    Post

    Z limit exceeded ... why?

    So if your using Ohmic you don't need to set the retract height ? AJ www.outlawchutes.com
    Post by: Fastyankee13, Apr 21, 2017 in forum: CNC Cutting
  3. Fastyankee13
    Post

    Set up for cutting corrugated metal

    Thank you AJ www.outlawchutes.com
    Post by: Fastyankee13, Apr 19, 2017 in forum: CNC Cutting
  4. Fastyankee13
    Thread

    Set up for cutting corrugated metal

    I 'm getting ready to do a run of corrugated metal on my 4x4 growth series with VHC. Any one ever done corrugated metal? I was just wondering the...
    Thread by: Fastyankee13, Apr 18, 2017, 7 replies, in forum: CNC Cutting
  5. Fastyankee13
    Post

    The Trooper_Iron Maiden .dxf

    The Trooper that's awesome . Eddie lives Andrew AJ Burr www.outlawchutes.com
    Post by: Fastyankee13, Apr 12, 2017 in forum: DIY Projects
  6. Fastyankee13
    Post

    Bench

    Nice work! Andrew AJ Burr www.outlawchutes.com
    Post by: Fastyankee13, Apr 12, 2017 in forum: DIY Projects
  7. Fastyankee13
    Post

    Contest entry. Off road independent suspension trailer.

    That's top notch fab work. Andrew AJ Burr www.outlawchutes.com
    Post by: Fastyankee13, Apr 12, 2017 in forum: Vehicle Builds
  8. Fastyankee13
    Post

    In-House and Regional Torchmate Operations Training

    I wish you were located in a easier place to fly in to, its been really hard trying to find a flight in to Reno from my location.
    Post by: Fastyankee13, Mar 25, 2017 in forum: CNC Cutting
  9. Fastyankee13
    Thread

    Scribing with Plasma

    With that new weld table build vid on Torch mate they scribed the lines out with the plasma. Is it possible to do this with a Hypertherm 45 with...
    Thread by: Fastyankee13, Mar 16, 2017, 2 replies, in forum: CNC Cutting
Find older messages
Showing results 81 to 89 of 89
Search Again
Page 5 of 5
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Accept Learn More...
    Dismiss Notice