Recent content by stjefrey

  1. stjefrey

    What's causing this?

    Check your filler metal. I've had spools left out in the open and oxidation can occur.
  2. stjefrey

    Tool Path Problems

    Looks to me like you made 2 tool paths? You probably have one on top another. Try re doing the original - make a duplicate- tool path male on the duplicate? Make sure you click on the "9" and not highlight everything (CTR-A) when you make a duplicate.
  3. stjefrey

    Accumove 2 stopped talking help

    I had a similar problem and ultimately had to replace the mother board on the Accumove 2. Call the good folks at Torchmate and see if they can help you?
  4. stjefrey

    Torch not coming down -Unable to cut -New machine

    Need more information? What machine do you have?
  5. stjefrey

    Diamond Plate?

    I may have a job next week cutting 3/16" diamond plate (steel) on my TM 4800. Any advise how to cut?? Should I have the diamond plate face down when cutting?
  6. stjefrey

    Ornate Steel Mailbox - Design | Cut | Build™ - S3.E12

    Great Job Arron and Iggy! I'm going try doing one out of stainless and in my neck of the woods, we have a flag on the right to let the mailman know we have mail to go out. I'll post pics when completed.
  7. stjefrey

    Torch dives after cut instead of retracting

    This worked for me, While running is the AUTO. Make sure you are using Sample Voltage as this will monitor the voltage while it is running and adjust based on the feedback. During cutting, verify that your voltage is stable. Also make sure your work ground is clamped to the material.
  8. stjefrey

    24g cutting

    "Anyone have any luck cutting 24g? It pierces but no move signal." I was having the same problem yesterday!?!? I would get some cuts but mostly pierces and no movement. Could it be the material was heavily oiled and not receiving a good ground?
  9. stjefrey

    Educators: Request Education Forum Access Here

    Please include me: Steve Frey Niagara Career and Tech CTR Sanborn, NY
  10. stjefrey

    Any words of wisdom on 24 ga

    Fixed the "Loss Cut" problem. The fine folks at Lincoln (Chad) helped me walk through it. He even emailed me on Sunday! Cut loss is a setting. Log on Admin Password 1234 Machine settings Input Change OK TO MOVE to USER Change the denounce to 0
  11. stjefrey

    Any words of wisdom on 24 ga

    I having the same problems. Did Dnmeistr-LECS suggestion work?
Back
Top