Recent content by SegoMan Designs

Thanks for the reply!

Greetings All. A quick question for you, I have an older 2x2 growth series table that runs TM 3 and TM CAD / CAM 9 on an older Win XP laptop. The laptop is getting old and needs replaced. Will these older programs run under the Win 10 & 11 OS? I notice they both have a compatibility mode to run...

Dawg gone good job

Any metal that thin is going to dimple with studs attached to it, I would go with some double sided bonding tape like this or spray adhesives (click the chat link and talk to them about it). build an alignment jig to properly align each pce before landing it. The acrylic is probably water jet...

Update, A mix ratio of .8 oz / gal of water yielded a PH of 11 so all is good and it should only cost about$20 to treat 350 gal. Thanks for the tips guys.

Thinktankgroup, Not trying to be a smart azz here but click on this link: https://www.youtube.com/ In the top search bar copy and paste the following: dust collection system Hit enter or click on the magnifying glass, allow time for the search and click on some of the vids.. Keep in mind...

Do a Y/T search for more ideas, keep in mind the smoother it is the less drag coefficient and better the flows. A cyclonic separator allows the heavier pcs to fall out before hitting the filter bag. Grounding is really important I can't stress that enough.

I use to have a 4" PVC sewer pipe manifold system my plastic shop then adapted from that to each machine as needed. Keep in mind that wood dust can be explosive and proper grounding is needed to prevent static discharge, Grizzly Industrial probably has the best supply of connections and dust...

2 feet it is! When you import this into TM it will cure the dreaded splines..

I have seen coffee table legs done to look like deer legs that turned out pretty good, what kind of foot you looking for People or animal?

^^ Yeah I did some additional reading and edited the post. The shop would not be the same if it did not stink like plaz smoke, folks wonder why I leave the swamp cooler uncovered for so long :cool:

What is the mixing ratio for the Washing soda? Pele' is going to have a 350 gal water tank.. Edit: Ok I did more reading on the thread, I'm assuming two 55 oz boxes / 100 gal is a good ballpark to start with. PH strips could be used for exact ratio. (I currentely use dynaflux)

Keith, How big of box you using and have you bought it yet? some metal suppliers sell galvanized products. Your going to need several tubes, acid - rinse - plating. I would recommend a conduit that a smaller tube could be lowered into for ease of clean-out. then a block and tackle up far...

YouTube is full of how too vids, PVC pipe comes in 20' sticks, Cut it to what ever length you want and set it in the ground with an over head hoist. Now who do you know with an auger truck?

I like blue :cool: the sign rocks too :) Did you put any vent holes in it? Not sure how hot it is that way but you need vent the hydrogen gas the battery produces.