Recent content by ryan thomas williams

update: It cut with less dross then meld steel at same speed and thickness.

Do i need to run this at a different speed then normal mild steel of the same gauge? trying to cut knife blanks for a friend and only gave me enough steel for the job.

Thank you for the response. I have all that turned on and it still does it. Its almost like it is traveling down to fast and cant react fast enough. Is there a way to slow it down? Some times i have to reset it 3-4 times before it will continue to cut and then it might happen on the very next...

Hello all, I have a 4x4 with height control and half way through a multi piece cut the machine will bottom out on the steel and it looses its Z axis. From here i have to raise the torch all the way up and reset Z. Then i go and reset the torch to steel height and hit run. Is this normal? When i...

UPDATE: I was able to ohm out the torch wires and found a wire that was not properly crimped on the plug side of the torch cable. Installed a new union and its back to cutting.

Powermax 65

Hello all I have a 4x4 table . I was half way threw a cut when the torch stopped cutting and threw code 0-52 ( no torch attached ). I tried unplugging and cleaning the connections , but that didn't work. I plugged in the hand held torch and the code goes away. Does anyone have any tips on...