Recent content by PopishFabrications

Hey guys, Thanks for any info you can give. As of the last couple weeks our torchmate 2 table has started lifting away from the material for about an inch after the pierce. It looks as if the avhc is lifting it to find the voltage but its lifting far enough away that it makes a noticeable non...

Awww makes sense. Would you please tell me the name of the usb cable? I think that might be the culprit

Also is that what the error meant or is the error just for a disconnected signal generator? Just curious about the error code

We are running the TM4 program and our torch is only about 2 foot away from our generator. I will definitely move it futher away just kinda strange that it wasn't happening earlier in the year. thanks for the reply

Hello everyone, Been running a torchmate 2 table since january and over the last month our signal generator has started to randomly disconnect from our computer and throwing the error 2001. I have searched for awhile online with no help and im about to call torchmate but thought I would ask...

thanks for the reply it was definitely some resistance in the lifter station. took out the guides and gave them a nice clean and lube and was off to the races. thanks again

Hello everyone, Just set up torchmate 2 table after shop move and our torch refused to drop down to the material. We are using the blue display avhc. Am going to take apart and give it a major cleaning tomorrow but is there anything else that could be doing this. I reinstalled all the software...