Recent content by MakeItWork

Thanks for the reply but it still double cut when I did this. But have since found out if I simply make a path and don't do the create path I only get one path. Going to also what the stuff that was posted by Chad. Don

Thank you, I will definitely have a look. Don

I am trying to make a simple 5 bolt drive plate. I use the circle shape tool I size the circle to .5 inches I got to array and set arc 360, number 5 on a 2.25 inch radius Then delete the middle circle Then create a new circle with 1 in radius and move to the center of bolt pattern The make...

New to this stuff so went to the video above and find that you here Mark Humphreys clicking the keyboard and clicking the mouse a minute 2o seconds into the video without explaining what he did and therefore I am lost instantly. Is there any other introduction videos that are more complete in...

When I start the system up I get motor not found message and cant access any screens, is this because it didn't find the motor or is it just not functioning properly? Don't know the cause any help would be nice. Thanks

The Lead screw is 10 tpi and 3/8" should anyone else need this info.

I want to build a torch height control and wondering what the lead screw pitch should be? Anyone know what is a good pitch. I will be using a Smart Motor SM2315D-BRKETH thanks Don