Recent content by Ken

Having issues with Note editing will only let me move one inch at a time instead of a little bit the same with dragging an image on the grid how can I get it back to normal

can you do that with 18 Ga. if so how? I am struggling with mine

This is a test run of different sizes. none of them cut the size I programmed it to

how do you get your machine to cut round holes, and cut the size you program it to cut?

Also any tips on where to set arc voltage cut height and cut speed on 16 ga.would be really appreciated. Having trouble fine tuning it. Thanks in advance

Two identical 9,s one cut and not the other same size and same font

Hi again. Go to cut object torch goes to to top of plate then comes up exceeds axis limits . What now just got done cutting out a project and went to this one

Is it possible to edit a dxf file after being saved? How can you do it ?thanks

Running on auto mode

This is a test cut I tried to run. Star in a square. Makes dry run great. It starts out good just go to hell after a bit

First of all make sure you got the right manual and parts to assemble it. The problem I am having is the torch start dragging after about 6" of cut . It just drops in the same place every time.

We got it about the 11th of July. I tried to get them to send that dongle key and disk but they said they would not separate the order like that.so we had to wait. Instead they sent me some videos that was of no use. We are still trying to get it going

Machine will do the dry run just fine perfect in fact but when I start to cut it gets about a quarter in to protect and starts Draging the torch every time and at the same place

Good luck getting a dangle key and disc. They refuse to send me that instead emailed me a bunch of worthless vids