Recent content by GS317

Adjust the magnet out so it sits closer to the torch clamp(magnet has a stronger bond the closer it gets)

The ability to cut thicker material, especially going to 1/2" like your asking, would require an upgrade of the plasma unit. 45 amps wont do well. Lots of bevel, super slow cut speeds, and shorter consumable life. Height control will help you control bevel on cuts and because you will have...

Try checking that the origin settings on the import screen are set to X:0 and Y:0, its possible its the kerf compensation but odd that it would offset like that...

What software is it for the driver? Sounds like gear ratio in the software might need adjusting...

Gotcha lol nice either v way

Is the second one painted?

The shield one is in our reading area(guess what books we like) i have 3 more Im gonna do from the same book series, the other is for a friend as a birthday present both I. Mild steel shield is .125, other is 3/16

Clever setup, wish i still had my jeep to do this with, super clean looking

Is there a designated spot for the ground star or do I just put it wherever?