Recent content by Chase

Have a customer wanting to cut 6x6 11g tube. has any tried this? We have a 4800

How would I check the plasma cutter. We have a 4800 table less then a year old. It was all installed by a certified electrician. I've had to run it with ok to move off and have all setting set off the book.

I've been having the same issue spent countless hours on the phone with support. Tried a ton of trouble shooting that even sent me a new interface cable. I'm about at the end of my patience. Everything is property grounded. No rush on material. It used to be if the fired it with the ok to move...

I have all the setting set according to the book same with the consumable stack. We are mostly cutting 10 and 12g mild steel. Would you suggest any different setting from the book. We are lucky to get 40 pierces. We are having alot of trouble with the torch coming down, piercing then not...

Flexcut 80. The air compressor is at 110 and the flex cut is right 80 when cutting. We have a 5 micro filter on the airline to the plasma, which I replaced the filter on not long ago.

Is this normal consumable wear? We are burning through consumables fast and we are still having issues getting the table the move after pierce

Sometimes changing out consumables will correct it but other times it won't make a Difference. I will change out the consumables long before they look worn. Feel like we are wasting alot of consumables because of this issue.

Have a 4800, flexcut 80. Having a problem with the torch firing for a fee seconds then shutting off. I've checked the psi, purged the air line to the flexcut, changes out consumables. Any advise on next step. It's frustrating and time consuming

I've watched all the videos and read the Manuals but I can't find anything that explains how to know what length lead in I should be useing or when to use a are, line or on line lead in?

Does anyone have the password for the 4800 user manual download? The one the salesman have us isn't working.