Recent content by Charles Hinze

Please disregard it screws out......feeling pretty dumb lol

Would anyone happen to have a guide to replace this? Thanks in advance I removed the motor and center shaft just fine I can not figure out how to remove the but tho

see above there was a rat playing around lol

I gathered that after you guys pointed me in the right direction. Any thoughts after 4 years it would change? ok So only torchmate stp lists anything in the io the torchmatex 5x10 says its for a newer version. After asking some questions apparently the boss formated and reinstalled everything...

ok Listed TMX 5x10.stp Tourchmate.stp Tourchmatex-servo.stp Torchmatex-stepper.stp Under recent setup I show in order Torchmatex-stepper.stp Tourchmatex-servo.stp Torchmate.stp Thanks For the help Guys

Ok So the only things listed are pierce signal and fault signal both are listed as open checked the wiring and everything appears ok Also I can not toggle anything if that helps

I agree thats why I went software first Thank you for the response I will keep you posted

Torchmate x Driver software is 4.0.61 Sorry

Just noticed today but none of our limit switches are working. were would one check this in the software? Thank you in Advance

Shop Vac or a 10.00$ drill pump works well depending on how often the water is changed

I hit print screen and then paste into photoshop (paint) works as well