Recent content by bcolea

Cole Andes Los Lunas High Los Lunas NM

houdy folks, I have an issue of constantly blowing drive cards on my older(~2008) torchmate 2. Best I can tell it is caused by my cables getting caught in the spur gears. Anybody have a creative solution? This machine is at a high school where I teach welding. Thanks

Having the same issue that the OP stated. Machine running fine, no error codes on cutter, torch will stop, machine will keep running. Usually after 3-5 seconds the torch will fire up again. We are not contacting the material with the tip. Pressures are constant( it's not a loss of pressure right...