DanGeorgian
Well-Known Member
pic 1 is the setup the previous owner was using.
pic 2 is the cabinet i just built for table equipment.
Yes its rather thick and over sturdy but im a structural welder by trade and this stuffs expensive.
No its not finished.
Thinking about using welding jacket leather to make a flap that snaps down the front to cover the openings.
Just have leads figure 8'd on prongs on the back but i dont like it and im thinking about some kind of hinging box cover off the back or something? lookin for ideas...
lmk what you think and post pix of what your setup
pic 2 is the cabinet i just built for table equipment.
Yes its rather thick and over sturdy but im a structural welder by trade and this stuffs expensive.
No its not finished.
Thinking about using welding jacket leather to make a flap that snaps down the front to cover the openings.
Just have leads figure 8'd on prongs on the back but i dont like it and im thinking about some kind of hinging box cover off the back or something? lookin for ideas...
lmk what you think and post pix of what your setup
Last edited by a moderator:
