MATCHING CORRECT SOFTWARE VERSION WITH SIGNAL GENERATOR DRIVER

[Justweldbaby]

I recently purchased an older 2x2 Torchmate. It looks to be in decent shape. No software or paperwork was included. Being that I have some basic experience using a Torchmate w/ Accumove 3 at work, I believed I could make my recent purchase work.
My first problem is I am not sure which version of software to download for my 501A signal generator/Driver. Serial Number #220319. Is it Version 3 or Version 4 ?Will downloading the wrong version damage my Driver ?
When I did download version 4 I was unable to connect to Signal generator. I figure this was a good place to stop and reach out for help. Any suggestions would be highly apreciated.

 

[LECS Hunter]

I recently purchased an older 2x2 Torchmate. It looks to be in decent shape. No software or paperwork was included. Being that I have some basic experience using a Torchmate w/ Accumove 3 at work, I believed I could make my recent purchase work.
My first problem is I am not sure which version of software to download for my 501A signal generator/Driver. Serial Number #220319. Is it Version 3 or Version 4 ?Will downloading the wrong version damage my Driver ?
When I did download version 4 I was unable to connect to Signal generator. I figure this was a good place to stop and reach out for help. Any suggestions would be highly apreciated.

Hello, thank you for reaching out on the forum. If you find it hard to get a response from the community, there are other resources you can try.
Here is a Facebook group you may find helpful. https://www.facebook.com/groups/170485276316053/about