I have problems with the table

[Karlo]

I follow the software process, to be able to cut with the lincoln 4400 but in the end the image or drawing is crookedhttps://www.imageupload.co.uk/image/TKPI

 

[Dnmeistr-LECS]

The VMD software has the ability to do plate alignment, possibly someone was messing around and did not realize what they were doing. To set your job back to square press Align Corner then press Align Edge without moving either x or y. See video on plate alignment here. https://livestream.com/torchmate/events/8268148

 

[Karlo]

I follow the software process, to be able to cut with the lincoln 4400 but in the end I see this on the plasma screen.

I follow the software process, to be able to cut with the lincoln 4400 but in the end I see this on the plasma screen.

https://ibb.co/kcXcyp

I follow the software process, to be able to cut with the lincoln 4400 but in the end I see this on the plasma screen.

[/QUOT

The VMD software has the ability to do plate alignment, possibly someone was messing around and did not realize what they were doing. To set your job back to square press Align Corner then press Align Edge without moving either x or y. See video on plate alignment here.

The VMD software has the ability to do plate alignment, possibly someone was messing around and did not realize what they were doing. To set your job back to square press Align Corner then press Align Edge without moving either x or y. See video on plate alignment here. https://livestream.com/torchmate/events/8268148

thank you it help alot