Fonts

Carlos Merino

Carlos Merino

Member
Hello, I’m doing a new project that requires 1 inch fonts in 14 ga carbon steel

so far have not been able to make it happen during the cut process since the letters are small and just loose them

any suggestions on a good font I can use? Basically I’m writing the Pledge of Allegiance in a Flag so nothing fancy or script

Thanks in advance
 
the easiest fonts to cut at one inch are block fonts like aerial bold..i tell my customers one inch letters are the smallest i cut
 
Yes, although it’s not been updated from some time now cause been involved in military contracts and didn’t think in posting them. This year we will resume an old project of retail selling through e-commerce and we will be posting quite a few
Our Instagram is @bluedogmiami
 
Carlos Merino said:
Yes, although it’s not been updated from some time now cause been involved in military contracts and didn’t think in posting them. This year we will resume an old project of retail selling through e-commerce and we will be posting quite a few
Our Instagram is @bluedogmiami
Click to expand...
Great, thank you! Do you design in Torchmate CAD?
 
Carlos Merino said:
Yes, although it’s not been updated from some time now cause been involved in military contracts and didn’t think in posting them. This year we will resume an old project of retail selling through e-commerce and we will be posting quite a few
Our Instagram is @bluedogmiami
Click to expand...

What font did you end up using. Great work
 
You must log in or register to reply here.

Similar threads

Torchmate
Stepper vs. Servo Motors...
Replies
0
Views
2K
Torchmate
Torchmate
Back
Top