Cad - break part into line segments

[BlueSteel]

Say for example I make a box, rotate it and add a few other dimensions. Is there a way to break it so it's line by line? I use the measure tool to measure a line on an angle but it's not exact and I need to be as close as possible.
Or is there a way to snap to an intersection (not grid)?
thanks

 

[Arkansas Metal Art]

If you wanted a 6” line and you know the angles you could add guidelines at the angles, snap a 6” box to that angled guideline and then draw a single line and snap it to the corner guidelines of the 6” box?

Or just rotate the box, add guidelines to each corner and snap to the corners?

 

[OcalaWill]

Say for example I make a box, rotate it and add a few other dimensions. Is there a way to break it so it's line by line? I use the measure tool to measure a line on an angle but it's not exact and I need to be as close as possible.
Or is there a way to snap to an intersection (not grid)?
thanks

If you do a lot of that consider getting a cad program like Autocad. I still use it for geometrical shapes as I find it much easier/faster to draw with than TM Cad. Then export the DXF.

 

[BlueSteel]

If you do a lot of that consider getting a cad program like Autocad. I still use it for geometrical shapes as I find it much easier/faster to draw with than TM Cad. Then export the DXF.

I have another cad program i use a lot, but its kind of pain to have certain files below to this cad and certain files below to that cad