flexcut 80

  1. J

    Flexcut 80 - Air/Gas light stays on- no air to torch on purge mode

    Flexcut 80 was working fine yesterday, started everything as normal, went to cut and no air/arc noticed air/gas light was on, on machine, disconnected air and reconnected and air purged for a few seconds then stopped. set amp dial to purge mode no air comes out also can't change cutting...
  2. P

    Fine cut consumables for Flexcut 80?

    First time poster on this forum. Well, any forum for that matter. I'm running a TM 4800 4x8 table with a Flexcut 80. I keep reading about "finecut consumables". However, I can't seem to find any for this torch. I have 40, 60 and 80amp nozzles for my machine. I'm getting pretty decent...
    • Pete F
    • Thread
    • fine cut consumables fine detail flexcut 80
    • Replies: 1
    • Forum: CNC Cutting
Back
Top