Does anyone know if there is a shortcut key for slow, medium, and fast jog speeds in the driver software version 4.5? I know the old white...
Oh yes I saw that listed on your e bay store. Can you confirm that this comes with version 4 driver software? If so I will go this ebay route as...
Dennie I attempted V4 but asks for the security code which I do not have. Can you tell me how much it is for his upgrade code? Also the funky...
Thanks Dennie. I was told by one of the techs that my S/N generator was not able to run version 4. However when I went to help then about TM in...
Update - any one of you TM techs come across this error? My signer generator does not have an expansion board but it says it does and I can not...
Hello I'm looking for a reply on here while I'm at work. I purchased a new to me 501a signal generator for my TM 1 table and hooked it up this...
I downloaded joytokey and use that program to assign the keys (purchase the $7 license or else it will erase everything when you shut off the...
Wanted to post an update. Added a start ground to my table frame. Ran the ground rod to it, plasma lead to it, ran ground wires to my gantry as...
Update: a fellow red screen user mailed me his spare box to test and I have the same results. Torch raises and loses arc randomly while cutting....
Good idea I will try this later and report back thanks.
I have a new to me used red screen height unit. Was acting funky so I sent it to Onexia for repair. They seemed to have issues but replaced a...
Thanks I completely understand! I tried to do this today on my spare drive box that has the 2305 driver cards but came to the conclusion one card...
I should state I have a 401a running 2.20 beta 14 driver software, which I use all version 3 manuals and pdfs for.
I tried to do this. I get an error in the driver software. I have three driver cards and one is unused so I was hoping another X would work. It...
I have a TM 1 4x8 and it has one stepper that runs the X axis. I have made a driveshaft to run across and put on a gear rack on opposite side to...
[ATTACH] Anyone have any info or experience with this old Torchmate Unit? I acquired it along with the z axis setup. I'm sure it's not great but...
I have a game controller controlling my table. I have info on how to do it if you are still interested. -Dan
Separate names with a comma.
