Cheers thanks for the help. Im sure i will have a few more questions down the track
I was wondering if it possible to make a pipe cutter from the old parts of our table that were removed when we upgraded to the accumove 3 system....
Setting are all fine and table is dead level and square. We have had a few idea's from the tech guys when we sent emails to them. Checked all the...
Anyone have any idea's on the z axis problem we have ?
No worries will send it through. I went into the IHS settings and it was already on ALWAYS. Should i just toggle it a few times to see if the...
Our machine was a torchmate 2 but has all the newer parts on it and runs accumove 3. The G code file was about 1.09Mb which I think was the...
Does anyone know what this error means ? Our machine will do it when about 90% through cutting a sheet with a reoccurring pattern. Then it won't...
If we get a breakaway or ohmic error the machine will stop straight away. We then clear the tip or whatever is in the way jog the torch back up to...
I have had no problem with the tech support. Always been good. We cut all day every day with our machine for fabricating and have done for about 5...
Any torchmate staff on here that can solve this for us ? Been waiting a while.....
Tried that today. Still not working just keeps reading a voltage of around 50 and the torch will either crash into the steel and stop or sometimes...
We are getting a reading of 399.50 with out the 9v battery attached. With the battery attached it goes down to 390.50. So this means the problem...
Righto we will give that a shot. Thanks !
Today we tried cutting a few different shapes that would activate the corner lockout. We also set the distance to corner lockout to 10'' so we...
Just thought I would say again. The table has been working fine for months. Is it normal for it to all of a sudden change like this ? We have also...
Cheers will try this tomorrow morning.
Had the plasma tested today to check the voltage. All is good with that, we where getting voltage readings pretty much what is listed in the...
We are having that tested to day and will let you know what we find. Yep sample voltage is on and its in auto. Torch dives all the time because...
Yeah we have tried speeding the machine up but still no luck
We basically cut non stop all the time for manufacturing. We run a torchmate 2 table with the accumove 3 controller. We have been running the same...
Separate names with a comma.
