I've tried that. It helps some, but within a couple of cuts it starts building up again. I was wondering if it has something to do with the oil...
I have a problem with molten metal building-up on the cap while the torch is making cuts in the clockwise direction. Cuts fine when cutting in the...
are the settings the same for the LC105 torch?
Any recommendations on settings for fine cut consumables on the flexcut 80? I tried various settings from the chart and can't get a good cut.
Thanks for the info.
I have a 4800 table and have been using the Green Cut plasma fluid. After a week of cutting, the water is no longer green and has turned to a...
Does the height increase affect the cut? I lowered the cut height to .005 on 1/8" metal to eliminate the bevel it was creating. Even at a cut...
Thanks, I'll try those settings and see how it works out.
I will try those and see what happens. Thanks for the info.
I tried cutting at .08 on the height, but it created a small bevel on the edges. So, I lowered to .05 and created a straight cut edge. I was...
Does it on 1/8" and 14 gauge metal. On the 1/8" material, I'm running a 40 amp nozzle at .05 cut height and 100 ipm.
I have the 4800 table with the flexcut 80. When making long, straight cuts, molten metal forms on the torch head and eventually causes it to...
Separate names with a comma.
