Torchmate

So today my 4X4 GS / Accumotive 2 crashed, dislodging the torch and it DIDN'T shut down and kept firing dragging along the metal while completely dislodged. Spoke to Alex and he had never seen that before. I videoed it and got it all. I was hoping I could upload the video here but do not see how. The last couple of jobs the torch dwelled a long time, probably 4 or 5 seconds before firing after initial touch off.

I bought a prepaid design and when I import the design into torchmate and make a path then create tool path it changes the size of the the 9 squares around the design. How do I stop that from happening. Also the program creates both male and female lead ins.

I have the old 401A signal generator and it will not power on. I have used it 3 years and no issues, Any suggestions on how to troubleshoot it? Thanks

When I make bridges for letters and I go to weld them the design is cutting out all the bridge, not just the part I want welded. I have tried everything I know to stop this to no avail. What am I doing wrong?

Is there a wiring diagram for the accumove 3 for the limit switches? I am trying to wire some prox switches for my limit switches for the datum and can't figure out if the white or black wire is the trigger or ground. Any help would be greatly appreciated.

I can not seem to figure out what changed but when I go save my G-code all I am getting is .nc file format and don't know what to do to get it to produce .gm files. Can someone please help me figure out what I did or how to get back to making .gm files

Just set up a 4800 with 80 amp unit. single stage compressor with 3 heads about 10' away. Heated garage.
Right out of the tank comes a regulator / sediment bowl filter ..
Q; Do I need to get a dryer just befor the machine or can I get away with a good quality filter just before the machine?

Can anyone give me an idea of what compressor to buy? I’ll be using the FlexCut 80 and the plate marker.

In need of some help with a design for my sheriffs dept and in a time crunch. Can someone help me out with design?

Hello, I have a torchmateX 5x10 with torchmate 3 software. I M trying gererate some G-code in the cad and I can seem to figure out how to change the feed rate for the tools when going to G-code. While setting up my tool paths I enter the feed rate I want, but when I generate the g-code the feed rate is at like 1500 when I set it to 90 ? How do I fix this other than manually changing it in the G-code.

Is it possible to get my name changed on here?