.gm file

Discussion in 'CNC Cutting' started by Dan Turner, Mar 2, 2017.

  1. Dan Turner

    Dan Turner Well-Known Member

    Joined:
    Dec 15, 2015
    Messages:
    48
    Likes Received:
    26
    Trophy Points:
    93
    Is there a setting in Torchmate CAD I need to change to output .gm files? Right now the only option is .fgl file format.
     
    Dan Turner, Mar 2, 2017
    #1
  2. Dan Turner

    Dan Turner Well-Known Member

    Joined:
    Dec 15, 2015
    Messages:
    48
    Likes Received:
    26
    Trophy Points:
    93
    figured it out, you have to go into Machining defaults and change to Accumove imperial.
     
    Dan Turner, Mar 2, 2017
    #2
    LECS-Chad likes this.
  3. Dnmeistr-LECS

    Dnmeistr-LECS Well-Known Member

    Joined:
    Dec 22, 2015
    Messages:
    705
    Likes Received:
    109
    Trophy Points:
    123
    And if you do not have an option for Accumove Imperial, Cad 7 or Cad 8, then you can download the Cad Patch from our website under support. After installed go to Machine Defaults then Setup and Load the Driver.
     
    Dnmeistr-LECS, Mar 3, 2017
    #3
  4. Dan Turner

    Dan Turner Well-Known Member

    Joined:
    Dec 15, 2015
    Messages:
    48
    Likes Received:
    26
    Trophy Points:
    93
    I was working with a local company, and they purchased a new computer to design on, and did not know how to get the .gm format. It is new software, I just had to remember how to set that up. It has been good to work with them, they have the accumove 2 and I have the accumove 3, so I get to see the difference so I can teach my students.
     
    Dan Turner, Mar 3, 2017
    #4
    Torchmate likes this.

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Accept Learn More...
    Dismiss Notice