Recent content by waynec

Hi again Just to bring this up.the machine seamed to work ok for a while but has started to plsy up again. This time it stops firing and a fault comes up on the plasma cutter.its a cutmaster a60. Fault code is 85 which comes up as a torch short. I have put a new torch on,but it is still the...

Thats great news.i shall call later.my motors are older and use the sauare type plugs.i dont mind upgrading as it should be like having a complete new machine. My machine runs a single motor on each axis..will it still work ok with thst set up.

ive had a look on youre website. can I purchase the acumove 2 as a stand alone system without the table. so I would need that,the software,two new stepper motors. and the cables to join it all together .my machine is a 8x4. another question.i had a brief look at the acumove 2.this doesn't...

yes I had a fault with my plasma torch. can my system be upgraded at all.if so what parts would I need I don't need to buy a complete machine,but maybe just the electronic side.when I got this many years back,thats how I purchased

different issue started today. in manual cut mode.it cut half the program,then the plasma stopped cutting. is this the control height box issue as well

if the fault is in the avhc control box,there isn't anything I can do is there . as its all electronics.ive checked the wiring at the plugs and all seams ok I have had one of these fail befor and needed a replacement. just to confirm.in manual mode it cuts perfect. in auto mode it skips...

Is that the black box with the voltage readouts on. Is there anything i can check. I did have to replace that about five years ago due to a fault. Is that part still avsilable to purchace

hi.ive opened the red box .what part is the relay in there,so I can find what wires to touch together

thanks.i shall check tomorrow. I watched the voltage on the panel,it suddenly goes from 112 to 0 and that's when its stops cutting. I will report back

hi.easier to enclose a couple of pics. one is the red box. the other the black one.in that picture,ive just changed the setting shown from auto to manual,and I didn't have any issues with my cut. im not sure what that does. should I still be looking for a relay.is that in the red or the black...

Thanks. What is the plasma relay box.is this the black box with the readout on,or the main red box

hello from the uk. ive run my torchmate machine for around ten years now.apart from the odd glitch,thats been resolved,it runs good. recently though,when cutting the torch will raise up ,miss part of the cut then go back down and cut again.it seams quite random.it will do it on one cut,but not...

thanks for that chad ill have a good look at it tommorow

hi from England. I run a torch,ate machine here in the uk. it has the hight controller. today I managed to run it into the bed by mistake,and now it will not work properly. when I start a program it will not move down to the metal. if I use the control box,i can manually move the height...