Recent content by taktoa

  1. T

    growth series problems...again

    what about 3/8 aluminum?
  2. T

    growth series problems...again

    or do you mean on the torch iself? if so its running at 83 amps
  3. T

    growth series problems...again

    the set voltage is set at 85 and the feed rate is 110 ips
  4. T

    growth series problems...again

    Like this
  5. T

    growth series problems...again

    and what about it burning too long in corners?
  6. T

    growth series problems...again

    are there any differences for aluminum?
  7. T

    growth series problems...again

    our edges and lead in cutting really deep and messing up our cuts as well as everything that we cut is bevled for some reason. its just giving an overall bad cut quality.
  8. T

    growth series problems...again

    i just cut out 3 test cuts and one turned out good the rest still did the same thing... should the active level be high or low, and should the breakaways be set to pause?
  9. T

    growth series problems...again

    Im using the VMD program and an Accumove 2. It will cut some weird shape but return to the same program zero as if it had just done the cut normally. And yeah on the computer it looks like its following the path on a dry run.
  10. T

    growth series problems...again

    so in a week one of my 4x4 growth table had its moter break, a bearing stick, and one of the drive belts break. after getting everything together and the new parts installed i ran the torch up and down the gantry and the drive shaft came loose and cost me more work. finally the torch started...
  11. T

    invalid feed rate?

    what does this mean and how do i get rid of it
  12. T

    breakaway replacment

    is there a way to get replacment breakaways? i tryed to find them on the torchmate website but i cant find any.
  13. T

    torchmate dongle error

    i switched it to a differant port and restarted my computer and it started working. thank you
  14. T

    torchmate dongle error

    idk what this means but my torchmate keeps crashing right after this shows up
  15. T

    weird ohmic thing

    so my ohmic has been down for about a week now. ive been waiting on getting a new VFC but in the mean time i switched the table to manual. this morning i turned on the machine and started to cut but i forgot to set the height. i noticed that the torch was still cutting and the ohmic was flashing...
Back
Top