Recent content by scbron

I am very disappointed that I am told my Accumove2 Motherboard is corrupted and needs to be replaced. My machine is just 3 years old. This should be covered by the warranty and it is not. This is wrong.

I may not have been clear. I am trying again because after talking to Tech Support, I am very confused because a new problem I am having is being attributed to a very old setup. I am now on my second 4x4 Growth Series Table with the Accumove 2 interface. My VMD software will not recognize my...

My VMD software will not recognize the Accumove connection. I have been succssfully running my VMD on a computer that is also connected to the internet via wifi. The address for the accumove is 192.168.1.6. I see that the wifi connection is on automatic and is currently 192.168.1.3 This has...

I was getting a language serialization error and was advised to uninstall and reinstall VMD. Now I cannot connect to my accumove. The black screen opens and hangs. I cannot ping the connection. I seem to recall having this problem before and having to set the ip addresses manually. I know the...

It may not be the backlash nut but it is also not the gantry. As I said in my post, I separated the backlash nut mount from the gantry and held the aluminum bracket in my had while it moved down the screw and it jammed in the same place without the gantry attached. I will reset the set screws on...

This is the problem that I submitted to TM. I have a 4x4 Growth Series. My gantry is binding near the end of its travel on the y axis. I removed the screws holding the gantry to the backlash nuts and it rolls smoothly along the whole length of travel. I then reattached each side individually...

Chad, What are we to do if the backlash nuts wear out on the 4x4 GS. It does happen and I need one to keep my one year old machine running. I had an earling TM table for 5 years and had to replace the backlash nuts on that one too. This part should be considered a consumable.

I bought my machine a year ago and they now tell me parts are unavailable. Lincoln has taken our money and left us on the side of the road. I am very disappointed. I need to replace my backlash nut and can get no information. I see there are others on the site who are having the same problem...

I am having the same problem, I have not gotten a reply from TM about getting this part. I am worried that it is not available.

I am still frustrated that Lincoln is increasing their energy towards selling more tables but doing nothing to increase the tech support staffing capacity. Every time a new machine is sold means that much longer a wait time for tech support. I called yesterday at 2:30. It is now 12:30 the next...

What proportions i.e. ounces/gallon do you find effective? Thanks.

I figured it out, Open Tool Library Set the incremental amount of travel Hit Toggle to initiate plasma arc Hit the directional arrow to move the distance entered in the incremental travel window Hit Toggle again to end the cut. Very helpful, more tips please

I am a Accumove 2. I was able to do the rip cut but I am not actually clear what the correct order of operations are. Could someone provide that as a step by step list. Thanks

I am currently in an older shop space and have a 2000 cfm open exhaust fan mounted on the wall next to my table and is reasonably effective in removing the shop smoke. The space is leaky and there is plenty of replacement air. When it is cold, I curtain off around the table to concentrate the...

Did you determine the kerf width by direct measurement? What kerf width is default on VMD and are there multiple widths already installed or do i need to create a plasma set up for each amp setup