Recent content by Ray

thats what i was thinking, sorry

So i have it, do you need the track, the picture is off the net, mine is brand new never used send me a message at y2kzr2@yahoo.com

i think i hve one, let me go check

I am currently running just that with no problems. 6.2.9.3

Larry, Im running 8 on 10, no problems

Very nice!

I had a similar problem, i would go to dry cut, and it was like a 10" part shrank to 2", then tm would freeze. After restart, problem would go away usually. A day later pc crashed, replaced lap top and problem went away. jdh239, you inspired me to get into cnc. Thank you for all you do, post...

Yes, did that as well.

No. its part of the copy right and software protection.. you can buy one from TM. Figure i will do my best to protect it

I have struggled with protecting the dongle from being inadvertently damaged. So i decided to put the dongle in a mini mag light box, drill a hole in the side and use an extension usb cable. i will put some Velcro on the monitor and box so i can remove and swap to my other pc. Not that big of...

Blue, shop around, i found on cl for under 200 still in the package. from sharpe, they are 5 bills plus

Will, bulk with site glass, i have been running on the same desiccant for 6 months lite use. here is a link http://www.sharpe1.com/sharpe/sharpe.nsf/Page/Dryaire+Desiccant+System

So, i am running a Quincy 50 cfm re fridge drier and a sharp model 6760 desiccant filter/drier that is used for the air supply to the Hypertherm 45 only. i have no problems with moisture.